My classmates and I are honored to have been assigned to the Creative Cutting Group for this Maker Week course, and we are even happier to have Professor Zhang to guide us. I used to know nothing about creative laser cutting. I thought it was high-end and upscale, but it turns out it's just so ordinary. I thought it would cut ordinary wooden boards, but it can also fulfill the dream of carving. Considering our first encounter, we may not be able to master this skill very well, but my classmates and I also don't want to miss this opportunity to challenge ourselves. After careful selection, we have chosen the material of the Ferris wheel. The main body of the Ferris wheel is3mmThe wooden board is laser cut and spliced together. Although its main body only consists of four parts, there are as many as a hundred components that make up it. approximately330mmThe width has also reached an astonishing level500mmSimple and elegant, with a certain degree of ornamental value. It took a week from composition to design, then to cutting and assembly. There were waves in the middle, some design flaws, and slight errors in proportion, but it was precisely because of continuous mistakes and corrections that we designed a relatively perfect Ferris wheel. When the final design draft was completed, oh my, it was just like that, and then after more than an hour of cutting. I thought this was the end, but I didn't expect it to be the beginning. After four hours of ritualistic assembly, my Ferris wheel finally had a rough outline, and after more than half an hour of unremitting efforts, it finally formed our rendezvous Ferris wheel. [austglcmp=1,600,500,0 extcredit=0]http%3A%2F%2Fvideo.laserblock.cn%2Fqiniu_F49B5F1D7C03B9913E51EEF58C6F21C1.mp4[/austglcmp]
|